The compact Airmix® painting pump is the ideal partner for your Airmix® spray guns, providing exceptional finish quality & high transfer efficiency.
ACCELERATOR OF PERFORMANCE
- Efficiency: perfect for Airmix® finish
- Optimization: built with minimal parts
- Simplicity: lowest cost of ownership
PERFORMANCE
- ♦Constant delivery and pulse free for superior finish
- ♦Priming at very low air pressure (0.6 bar)
PRODUCTIVITY
- ♦Large foot valve to handle high viscosity materials up to 5,000 cPs
- ♦A closed construction to prevent from risk of injuries & to protect lubricant from external contamination
- ♦Quick maintenance thanks to an easy rotable outlet fitting
- ♦Facilitate pump priming & flushing thanks to a design made to eliminate dead zone: time saved
- ♦Leak monitoring vent hole for fast control
- ♦A quiet air motor make very low noise
SUSTAINABILITY
- ♦45% less part vs competitors for the air motor to provide a better maintenance
- ♦Differential air motor to avoid the paint pump from frost
- ♦Ultra coated pluger for less friction & improved abrasion resistance
- ♦Single GT seal to avoid throat packing maintenance & low friction & offers a large lubricant wet cup
| Designation | Value | Unit: metric (US) |
|---|---|---|
| Pressure Ratio | 15/1 | |
| Maximum Fluid Pressure | 90 (1305) | bar (psi) |
| Maximum Air Pressure | 6 (87) | bar (psi) |
| Air Consumption | 2.8 (1.65) | m³/h (cfm) |
| Maximum Temperature | 60 (140) | °C (°F) |
| Weighted Sound Level | 71.2 | dBA |
| Recommended Air Pressure | 2 – 5 (29 – 72.5) | bar (psi) |
| Fluid Output at 30 cycles/mn | 0.75 (0.2) | l/min (gal/mn) |
| Fluid Output at 20 cycles/mn | 0.5 (0.13) | l/mn (gal/mn) |
| Fluid Volume per Cycle | 25 | cc |
| Free Flow Rate | 1.5 (0.39) | l/mn (gal/mn) |
| Fluid Output at 15 cycles / mn | 0.375 (0.01) | l/mn (gal/mn) |
| Air Consumption at 30 cycles/mn at 4 bar (60 psi) | 2.8 | m³/h (cfm) |
| Displacement Per Cycle | 25 (1.52) | cc (cubic inch) |
| Motor Type | 245-4 | |
| Air Inlet | F3/8″ BSP / F3/8″ BSP | |
| Fluid Outlet | F 3/8 ” NPS / M1/2 JIC | |
| Fluid Inlet | F 1/2 ” BSP / M26x125 | |
| Hard Chrome Stainless Steel, Wetted Parts | ♦ | |
| Number of Cycles per liter of products | 40 | |
| Sealing Packing Upper and Lower GT polyethylene | ♦ | |
| Height | 57.5 (22.6) | cm (in) |
| Width | 32 (12.6) | cm (in) |
| Depth | 17 (6.69) | cm (in) |
| Wetted Shares: Stainless Steel | ♦ | |
| Weight | 7.7 (17) | kg (lbs) |
